HURRISAFE 9450 Parts Washer Degreaser With Rust Inhibitor Aqueous Cleaning Solution For Parts Cleaners NSN 6850-01-436-86915-Gallon PailNSN 6850-01-436-830255-Gallon Drum
HURRISAFE 9450 is an excellent water based cleaning agent for replacing solvents, especially 140° to 150° F flash point napthas typically used in manual and automated parts cleaners.HURRISAFE 9450 is a highly concentrated, aqueous, non-flammable, very low VOC cleaning agent that removes typical oil/grease and other soils more effectively and dries much more rapidly than the high flash point (>140° F) solvents used today throughout the manufacturing industries.
HURRISAFE 9450 contains special corrosion inhibitors which provide protection for even those metals most susceptible to corrosion including hardened tool steel and cast iron.
HURRISAFE 9450 is used in parts cleaners in the same manner as solvents.Heat is not required.In typical use, one drum of HURRISAFE 9450 replaces approximately four drums of solvent.The oil-splitting properties of HURRISAFE 9450 provides for a much extended bath life compared to solvents.
HURRISAFE ADVANTAGE:
1. Low VOC content. 2. Excellent heavy duty cleaning performance due to state of the art chemistry and exceptionally high concentration. 3. Improved worker safety due to dramatically reduced inhalation and skin exposure effects contains no sodium hydroxide or potassium hydroxide. 4. Readily Biodegradable per EPA 40CFR796.3200 (>60% degradation in ten day BOD test). 5. HURRISAFE 9450 contains no EPA reportable substances (SARA, HAP?s, RCRA, etc.). 6. Spent cleaning agent and rags are not hazardous wastes unless the removed soils are themselves hazardous wastes. Typical spent HURRISAFE 9450 waste passes the hazardous waste TCLP test. 7. Non-flammable, non-combustible, no flash point 8. Compatible (non-corrosive) with nearly all metals (including aluminum, copper, brass, cast iron) and plastics. 9. Dilutible with water to tailor performance to soil type amount, and to optimize economics. 10. PCI of America provides strong technical service nationally for parts cleaning and a broad range of other industrial cleaning applications.Product is available locally throughout the United States. 11. HURRISAFE 9450 ships as a Class 55 non-hazardous material.
DIRECTIONS:
For most industrial parts cleaning applications, HURRISAFE 9450 is diluted with water for use in parts cleaners as shown below, and is then used according to the same cleaning procedures historically employed with solvents.These procedures are specified by the equipment manufacturers. Dilution 3:1 ( water to Hurrisafe Degreaser)
SAFETY:
Rubber gloves are recommended to prevent drying of the skin and goggles if splashing is expected. Refer to MSDS for detailed safety instructions for use.
DISPOSAL:
Spent HURRISAFE solution is disposed of through a waste water treatment company or through sewer discharge to a local POTW, depending on local water discharge limitations.HURRISAFE is a non-hazardous waste and is readily biodegradable by the EPA definition. The soils added to the HURRISAFE solution may change the waste characterization.The same reasoning holds for waste rags.They are only a hazardous waste if the removed soil is itself a hazardous waste.
